Washer repair service in Toronto
A malfunctioning washer disrupts your whole routine. We repair front-load, top-load, high-efficiency, stackable and compact washers — same-day wherever we can.
Book your washer repair

Accurate diagnosis, genuine parts, repairs that last
A malfunctioning washing machine can disrupt your entire routine, especially when laundry piles up. Whether you’re dealing with a front-load, top-load, high-efficiency or compact washer, we provide comprehensive repair tailored to your appliance’s make and model.
Our certified technicians work on all major brands and washer types — standard or smart, including stackable units and all-in-one washer-dryer combos. From modern machines with touch displays to older mechanical models, we make sure yours runs like new.
- Accurate diagnostics before any part is replaced
- Genuine, manufacturer-approved parts
- Price agreed before work begins
- Satisfaction guaranteed
Common washer problems we solve
Click through for what usually causes each fault — and what the labour typically costs.

Washer won’t start
A washer that won’t power on can come down to faulty door latches, defective timers, blown fuses or control-board failure. We inspect both the electrical and mechanical components to pinpoint the cause.

Washer won’t spin
If your machine fills but doesn’t spin, think worn belts, lid switches or a failed motor coupling. We assess the drive system, transmission and spin control to get your laundry moving again.

Loud noises & violent shaking
Unusual sounds during a cycle may point to worn drum bearings, loose motor mounts, tired dampers — or a foreign object caught in the drum or pump. A full diagnostic stops the noise and prevents further damage.

Washer is leaking
Leaks stem from damaged hoses, faulty door seals or worn pumps. Whether it’s a puddle under a front-loader or a drip at the hose connection, we find the source and give a lasting fix.

Washer won’t drain
A washer that won’t drain can mean a clogged pump, a blocked hose or an electrical fault in the control system. We clean the drain path and replace whatever has failed.

Smells bad
Mould and bacteria build up in the door gasket and detergent drawer, causing foul odours. We deep-clean, replace damaged seals and show you how to keep the machine fresh.

Door won’t lock or open
A door that won’t lock stops the cycle cold; one that won’t unlock holds your wet laundry hostage. We repair latches, lock assemblies and lid switches.

Error codes & dead display
Modern washers display error codes for everything from door-lock failures to sensor faults. Our technicians decode them for your exact brand and model and fix the cause.
Not sure what’s wrong? Use the symptom finder
Won’t start
A washer that won’t power on is usually a faulty door latch or lid switch, a failed timer or a control-board fault. We test both the electrical and mechanical sides to pinpoint the cause.
for this problem$99–249
Won’t spin
If it fills but doesn’t spin, think worn belt, lid switch or a failed motor coupling. We check the drive system, transmission and spin control to get laundry moving again.
for this problem$99–249
Loud noises
Banging or roaring in a spin points to worn bearings, dampers or suspension — or something stuck in the drum. We run a full diagnostic before any part is touched.
for this problem$199–299
Leaking water
Leaks come from a handful of places: a split hose, a torn door boot, a failing pump or a worn tub seal. We find the exact source and give you a lasting fix.
for this problem$99–249
Won’t drain
Standing water usually means a clogged pump or filter, a blocked hose or a control fault. We clear the drain path and replace whatever has failed.
for this problem$99–249
Won’t fill
No water, or very slow water: a failed inlet valve, a bad water-level sensor or a control signal problem. We check the supply side and the electronics.
for this problem$99–249
Smells bad
Mould and bacteria love door gaskets and detergent drawers. We deep-clean, replace a damaged boot if needed and show you how to keep it fresh.
for this problem$99–249
Error code / dead display
Modern washers display codes for everything from door-lock failures to sensor faults. We decode the code for your exact brand and fix the cause, not just the symptom.
for this problem$179–249
Agitator won’t move
Top-load agitator limp while the motor hums? Stripped agitator dogs or a worn belt are the usual suspects, and both are fast fixes.
for this problem$99–199
Labour prices at a glance
Every repair sits in one of three tiers. Open the full price list to see each repair.
- Drive belt replacement$99–199
- Lid switch / door lock assembly$99–199
- Agitator dogs$99–199
- Water level / pressure switch$99–199
- Motor coupling$99–199
- Drain pump replacement$199–249
- Water inlet valve$199–249
- Motor control board$199–249
- Door boot seal / gasket$199–249
- Shock absorbers$199–249
- Tub bearing replacement$199–299
- Spider arm assembly$199–299
How we compare
What you should expect from any washer repair company — and what you get with us.
Washer repair FAQ
How much does washer repair cost in Toronto?
Most washer repairs fall between $99 and $299 in labour, depending on the part: quick fixes such as belts, lid switches and hoses are $99–$199, standard repairs like drain pumps and control boards are $199–$249, and major jobs like tub bearings are $199–$299. Parts are quoted separately and you approve the total before work starts.
Do you offer same-day washer repair?
Yes. We offer same-day washer repair across Toronto and the GTA whenever availability allows. Book online early in the day for the best chance.
Is the service call really free with a repair?
Yes. When you go ahead with the repair, the service call fee is waived — and booking online also takes $25 off.
Which washer brands do you repair?
All major residential brands, including Whirlpool, Maytag, Kenmore, GE, Samsung, LG, Frigidaire, Electrolux, Bosch, Miele, Speed Queen and more. We repair front-load, top-load, high-efficiency, stackable, compact and all-in-one washer-dryer combos.
Should I repair or replace my washer?
As a rule of thumb, if the repair costs less than about half the price of a comparable new washer and the machine is under about 10 years old, repair makes sense. Use the calculator on this page, or ask our technician for an honest opinion on the spot.
How long does a washer repair take?
Most washer repairs are finished in one visit — typically one to two hours. If a specific part has to be ordered, it can take a few days.
Do you use genuine parts?
Yes. We use manufacturer-approved, high-quality parts so the repair lasts, and the work is backed by our satisfaction guarantee.
What if the washer can’t be fixed?
We’ll tell you honestly. If a repair doesn’t make financial sense, we’ll explain why before you pay for any work.
Washer acting up? Get it fixed today.
Book online in a minute — same-day service, upfront pricing and $25 off your repair.









