Washer repair cost in Toronto
Honest labour prices, shown up front. Explore 20 common repairs, filter by your washer type, and see exactly where your fix falls — from $99.
Book your washer repair
$99
Belts, lid switches, hoses and other quick fixes start here.
$249
Pumps, valves, boards and seals — the bulk of our work.
$0
Waived when you go ahead — plus $25 off when you book online.
Know what’s wrong? Find your repair
Filter by problem area and washer type. Each card shows the typical labour range and where it sits on the $99–$299 scale.
Drain pump replacement
Water inlet valve
Motor control board
Drive belt replacement
Door boot seal / gasket
Lid switch / door lock assembly
Shock absorbers
Suspension rods
Agitator dogs
Tub bearing replacement
Spider arm assembly
Water level / pressure switch
Shift actuator
Motor coupling
Clutch assembly
Timer assembly module
User interface / touchpad board
Drain hose replacement
Coin trap / filter clearing
Tub seal replacement
No idea what’s broken? Start with the symptom
Pick what your washer is doing and see the likely repairs and a realistic labour range.
Won’t start
A washer that won’t power on is usually a faulty door latch or lid switch, a failed timer or a control-board fault. We test both the electrical and mechanical sides to pinpoint the cause.
for this problem$99–249
Won’t spin
If it fills but doesn’t spin, think worn belt, lid switch or a failed motor coupling. We check the drive system, transmission and spin control to get laundry moving again.
for this problem$99–249
Loud noises
Banging or roaring in a spin points to worn bearings, dampers or suspension — or something stuck in the drum. We run a full diagnostic before any part is touched.
for this problem$199–299
Leaking water
Leaks come from a handful of places: a split hose, a torn door boot, a failing pump or a worn tub seal. We find the exact source and give you a lasting fix.
for this problem$99–249
Won’t drain
Standing water usually means a clogged pump or filter, a blocked hose or a control fault. We clear the drain path and replace whatever has failed.
for this problem$99–249
Won’t fill
No water, or very slow water: a failed inlet valve, a bad water-level sensor or a control signal problem. We check the supply side and the electronics.
for this problem$99–249
Smells bad
Mould and bacteria love door gaskets and detergent drawers. We deep-clean, replace a damaged boot if needed and show you how to keep it fresh.
for this problem$99–249
Error code / dead display
Modern washers display codes for everything from door-lock failures to sensor faults. We decode the code for your exact brand and fix the cause, not just the symptom.
for this problem$179–249
Agitator won’t move
Top-load agitator limp while the motor hums? Stripped agitator dogs or a worn belt are the usual suspects, and both are fast fixes.
for this problem$99–199
Three tiers, zero surprises
Every washer repair falls into one of three price tiers. Here is what sits in each.
- Drive belt replacement$99–199
- Lid switch / door lock assembly$99–199
- Agitator dogs$99–199
- Water level / pressure switch$99–199
- Motor coupling$99–199
- Drain pump replacement$199–249
- Water inlet valve$199–249
- Motor control board$199–249
- Door boot seal / gasket$199–249
- Shock absorbers$199–249
- Tub bearing replacement$199–299
- Spider arm assembly$199–299
What’s included in every repair
Full diagnosis
We find the real fault before replacing anything, so you don’t pay for parts you don’t need.
Service call waived
The service call fee is waived when you go ahead with the repair. Book online and take $25 off too.
Genuine parts & guarantee
Manufacturer-approved parts, a full test cycle and a satisfaction guarantee on the work.
What affects the price?
The part
Labour is only part of the bill. Parts are quoted separately because cost varies hugely between a $15 hose and a control board for a premium model.
The washer type
Front-loaders usually take longer to open up than top-loaders; stacked units and built-in installs add access time.
The brand & model
Premium European brands often need specialist parts. We confirm the exact part and price before ordering anything.
Repair or replace?
If the repair quote is under about half the price of a new washer — and your machine is in decent shape — repair usually wins. Check yours.
Pricing questions
How much does washer repair cost in Toronto?
Most washer repairs fall between $99 and $299 in labour, depending on the part: quick fixes such as belts, lid switches and hoses are $99–$199, standard repairs like drain pumps and control boards are $199–$249, and major jobs like tub bearings are $199–$299. Parts are quoted separately and you approve the total before work starts.
Is the service call really free with a repair?
Yes. When you go ahead with the repair, the service call fee is waived — and booking online also takes $25 off.
Should I repair or replace my washer?
As a rule of thumb, if the repair costs less than about half the price of a comparable new washer and the machine is under about 10 years old, repair makes sense. Use the calculator on this page, or ask our technician for an honest opinion on the spot.
What if the washer can’t be fixed?
We’ll tell you honestly. If a repair doesn’t make financial sense, we’ll explain why before you pay for any work.
Do you use genuine parts?
Yes. We use manufacturer-approved, high-quality parts so the repair lasts, and the work is backed by our satisfaction guarantee.
Know your price. Book your fix.
Book online, get a technician out the same day when we can, and save $25 on the repair.
